Your needs, this model
Does it fit your priorities?
Does the manufacturer’s 7,200 BTU/h SACC title meet your cooling minimum?
Haier’s exact title explicitly labels 7,200 BTU/h as SACC. The feature/detail row separately says 7,100 BTU/h cooling capacity without restating the test basis; the product review keeps that discrepancy visible. The listing does not meet an 8,000-SACC minimum.
Explore this need in the finder →Will the standard 20–46-inch window panel fit your clear opening?
The exact product page and the QPCA10-family installation instructions specify a 20–46-inch opening. A measured 46-inch opening is within the printed range; 47 inches is not confirmed.
Explore this need in the finder →Is app control essential for this exact suffix?
The exact page shows a general SmartHQ/Wi-Fi promotion and the family manual says Wi-Fi applies only to selected models. Check the connected-appliance label on the specific unit; do not rely on app support unless it is verified for QPCA10YBMW.
Explore this need in the finder →Can you use gravity drainage only while running Dry mode?
For extended Dry-mode use the linked manual describes an upper-port, half-inch-OD gravity hose to a floor drain. It does not confirm continuous cooling drainage or a built-in pump, and it does not establish that the hose is included.
Explore this need in the finder →Earlier Haier portable air conditioner
Haier QPCA10YBMW review: a 7,200-SACC listing with an important capacity caveat
QPCA10YBMW is a single-hose unit aimed by Haier at medium rooms. Its exact page identifies a 7,200 BTU/h SACC headline, 10,000 BTU/h ASHRAE rating, 350-square-foot maker estimate and a 20–46-inch window-kit range. It also says this model is no longer being manufactured. The detailed page repeats 7,100 BTU/h as cooling capacity, so that discrepancy deserves attention before choosing it by capacity alone.
Read the capacity labels carefully
Haier’s exact model title labels 7,200 BTU/h as SACC and 10,000 BTU/h as ASHRAE. Lower on the same page, a feature paragraph and the “Cooling BTUH (MAX)” specification say 7,100 BTU/h without naming that figure SACC. Those numbers should not be silently blended. The 7,200 figure is the manufacturer’s explicitly labeled SACC claim; the separate 7,100 detail is preserved as a source conflict. That leaves this model below an 8,000-SACC requirement, and the area estimate is not a substitute for sizing a room with high sun, poor insulation or frequent door opening.
Keep the full model suffix in view. QPCA10YBMW is not the same product as QPCA10YZMW, despite the shared QPCA10 family label. The latter is a separate configuration with a different page-listed SACC value. Do not use a nearby Haier model’s capacity, controls or kit details to fill gaps for this one.
Measure the window and leave room around the cabinet
This is a single-hose design: a five-foot exhaust hose carries hot air out through the supplied window kit. Haier specifies a 20-to-46-inch opening for the panel. The manual asks for 20 inches from an exterior wall and at least 30 inches on the other sides, and cautions against blocked airflow, an unstable raised surface, direct sun and nearby heat sources. Measure the clear opening rather than the sash’s advertised size, and check that the hose can reach without being crushed or sharply bent. If your opening is wider than 46 inches, this standard kit is not confirmed to fit.
At 24.75 inches tall, 15.25 inches wide and 14 inches deep, the cabinet is still a substantial appliance at 51.6 pounds. Casters help with rolling on a level floor, but the manual calls for two people to move and install it. The room-size figure does not account for all the practical constraints: an awkward window, blocked outlet or narrow path can matter more than a headline square-foot estimate.
Cool, dry and fan are different jobs
The exact Haier page describes three modes: Cool, Dry and Fan. It lists three fan speeds, an automatic louver, remote control, a 24-hour on/off timer and auto restart after a power interruption. The published noise figures are 52 dBA on low and 55 dBA on high; treat these as manufacturer specifications, not a room test. The cooling setting range is 64–86°F. The unit is rated at 115 volts, 8.5 amps and 980 watts, and uses a standard grounded connection. Haier’s manual warns against adapters and extension cords, so plan for a suitable outlet close to the appliance.
Do not read the family manual’s “Heat (on some models)” instruction as proof that this exact suffix heats. The exact product page lists a three-mode cooling/dehumidifying/fan configuration, not a heat mode.
Water handling depends on the mode
Haier says the unit evaporates condensate in most room conditions, but the manual still describes a full-water indicator, automatic stop and lower manual drain. If the tank fills, the appliance must be drained before cooling resumes. For extended Dry-mode use, the manual describes a separate upper-port gravity hose with a half-inch outside diameter leading to a floor drain. This is not a built-in lift pump, and the manual does not establish continuous hose drainage while cooling. It also does not establish that the gravity hose comes in the box. If unattended cooling drainage or a pump is essential, choose a configuration whose exact documentation confirms that arrangement instead.
Care is straightforward but not zero-effort: the owner’s manual says to clean the removable air filters at least every two weeks and to disconnect power before cleaning. Washable filters are useful only if they are accessible and returned to the appliance before it runs.
Connectivity and purchase checks
The exact product page displays Haier’s SmartHQ/Wi-Fi promotional section, but that section does not establish that QPCA10YBMW itself has connected controls. The family manual says Wi-Fi applies to selected models and directs owners to check for a connected-appliance label. If app control is a must-have, verify that exact unit’s label and compatibility with Haier before buying; otherwise treat app support as unknown.
Haier identifies QPCA10YBMW as no longer manufactured. A listing that uses the same family name is not proof of stock, warranty coverage or exact suffix. Confirm the model plate, included window parts and seller’s written return terms. If you need a larger documented SACC tier, compare the distinct QPCA12YZMW or another currently supported model by its exact manual and ratings rather than assuming this YBMW unit is interchangeable. For room cooling, the most useful deciding facts here are the measured window span, available clearance, the 7,200-SACC title claim versus the 7,100 detail, and whether Dry-only gravity drainage is enough for your use.
Key details at a glance
| DOE seasonal-adjusted cooling capacity | 7200 BTU/h |
|---|---|
| Manufacturer's stated room area | 350 sq ft (stated, not a guarantee) |
| Documented modes | cool / dry / fan |
| Dual-hose exhaust arrangement | No |
| Manufacturer's lowest sound claim | 55 dBA (claim, not our measurement) |
| Cabinet width | 15.25 in |
| Cabinet height | 24.75 in |
| Cabinet depth | 14 in |
| Listed product weight | 51.6 lb |
| Listed limited warranty | 1 years |
| Window-kit minimum width (where exact manual confirms) | 20 in |
| Window-kit maximum width (where exact manual confirms) | 46 in |
| ASHRAE cooling rating (separate test method) | 10000 BTU/h |
| Supplemental heat documented | No |
Use the exact model’s instructions for operating limits, supplied equipment and version differences.
Sources for this assessment
Keep the model number in the decision.
Check the listed suffix, included vent kit, room conditions and service instructions before ordering.