Your needs, this model
Does it fit your priorities?
Does its 8,000-BTU/h DOE rating meet your minimum cooling threshold?
The exact EnergyGuide/spec list 8,000 BTU/h DOE. An 8,000-BTU/h DOE minimum passes; a 10,000-BTU/h minimum does not, even though the separate ASHRAE headline is 12,000.
Explore this need in the finder →Will the documented uncut slider panel span fit your clear opening?
The page-linked guide lists 26.6–52.5 inches for its standard panel. A 40-inch opening is within that span; the guide allows cutting below the lower value but does not state a finished minimum.
Explore this need in the finder →Can your installation use the model's single exhaust hose?
The exact model sheet lists one exhaust hose, so a single-hose requirement is supported and a dual-hose-essential requirement is not.
Explore this need in the finder →Is connected app control essential?
The model-specific sheet lists Wi-Fi enabled, and the exact product page calls the model connected. This supports an app-control requirement; a remote is also listed.
Explore this need in the finder →Does the portable AC itself need to heat the room?
No. The exact sheet marks supplemental heat as absent; a shared guide's conditional heating text does not turn this cooling-only SKU into a heater.
Explore this need in the finder →Can the 28-inch cabinet height fit below your opening or shelf?
Frigidaire lists a 28-inch body height; a 29-inch limit fits the listed height, while a 27-inch limit does not. Leave additional space for placement and airflow.
Explore this need in the finder →Do you have a lower drain for continuous use in Dry mode?
The linked guide says Dry mode uses a separately obtained garden hose routed downhill to a drain below the unit. A built-in lift pump is not confirmed, so an essential pump requirement remains unsupported.
Explore this need in the finder →The Frigidaire FHPW122AC1 is a connected cooling-only portable air conditioner rated 8,000 BTU/h DOE. Frigidaire also lists 12,000 BTU/h ASHRAE; that different-method figure is not a 12,000-BTU/h DOE rating. Its 251–350-square-foot room band is planning guidance, not a guarantee.
Start with the 8,000-BTU DOE figure
The exact model specification sheet and EnergyGuide identify FHPW122AC1 at 8,000 BTU/h DOE and 12,000 BTU/h ASHRAE. The EnergyGuide gives CEER 7.2 and an estimated annual operating cost of $108. These are useful label comparisons, not an estimate of your individual bill or an independent performance test. Actual run time, room heat load and electricity rates vary. Use the DOE number when comparing the capacity options in this finder; do not compare an ASHRAE headline directly with a DOE/SACC threshold.
This model sits between Frigidaire's smaller FHPC102AC1 at 6,500 BTU/h DOE and the larger FHPC142AA1 and FHPH142AA1 at 10,000 BTU/h DOE. The 122 offers more labeled cooling than the 102 while retaining the compact 28-by-16.5-by-14-inch cabinet dimensions, but it weighs 69 pounds rather than 62. It is not the 10,000-BTU tier, and it does not add heat.
Connected operation and air features
The exact product page describes a three-in-one arrangement: air conditioning, fan operation and a dehumidifying Dry mode. The model-specific sheet lists three fan speeds for cooling and fan use, a swing louver, sleep mode, auto fan, a 24-hour on/off timer and automatic restart. It also lists Wi-Fi, a remote control and a clean-air ionizer. That combination is more convenient than a basic manual-control configuration if you intend to use phone control, but neither Wi-Fi nor the ionizer is evidence of measured cooling performance or a medical-grade air-cleaning result.
The dust filter is washable. The linked owner's guide gives a weekly cleaning interval during operation and describes a separate advanced filter as an optional replacement item; the model sheet also lists an advanced-filtration option. Do not treat the washable dust filter, ionizer and optional replacement filter as the same component. If you need the optional filter, confirm its compatibility and current availability before purchase.
Plan the exhaust and window fit first
This is a single-hose portable AC with an included window kit, not a dual-hose design. The page-linked guide's standard sliding panel is listed for 26.6 to 52.5 inches, so a 40-inch measured opening falls inside the documented uncut span. The guide permits cutting the panel below its stated minimum but does not provide a finished lower limit. A narrow opening therefore needs a physical compatibility check rather than an assumed number. The manufacturer lists a 6-inch hose and a 59-inch maximum. The spec sheet says a 10.6-inch minimum hose length, while the linked July 2019 guide describes the supplied hose as 15 inches before extension. Since those minimums conflict, I would not use a hose-minimum requirement to decide fit. Keep the run short and free of sharp bends or sags, and check the outlet, sash and hose path together.
The same generic guide says to leave at least 31.5 inches front and back and 19.7 inches at each side. Treat these as the manufacturer's installation clearances, not as the cabinet dimensions. The body itself is 28 inches high, 16.5 inches wide and 14 inches deep; Frigidaire lists product weight at 69 pounds. Measure the room's turn into place as well as the footprint, and do not interpret caster wheels as proof that a 69-pound appliance is easy to lift or carry.
Cooling and Dry mode need different water plans
The linked guide distinguishes ordinary cooling from continuous dehumidification. For Cool or Auto, it recommends closing the continuous-drain outlet to reach maximum cooling performance; residual water can still need collection and draining. In Dry mode, it calls for a separate garden hose routed downhill to a drain below the unit. The specification confirms continuous-drain operation but does not establish a built-in condensate lift pump. If your only drain is higher than the AC, do not assume this model will pump water uphill. Fan-only operation is different again: the guide says the exhaust hose is not required in Fan mode.
The sheet lists 115 volts, 12 amps and 1,100 watts in cooling, plus R-32 refrigerant and a one-year parts and labor warranty. The page-linked guide requires a properly grounded wall outlet and warns against extension cords or adapter plugs. This deserves attention in an older room or at a distant window: plan the outlet and cord location before settling on a cabinet position.
Who should compare it with the other Frigidaire models?
Choose FHPW122AC1 when the documented 8,000-BTU DOE tier, compact footprint and app-connected controls fit the room and your setup, and when a single hose and gravity drainage for Dry mode are acceptable. Compare the smaller FHPC102AC1 if 6,500 BTU/h DOE is enough and a lower listed weight matters; compare FHPC142AA1 if you need the 10,000-BTU DOE cooling tier but no heat; compare FHPH142AA1 only if supplemental heat is genuinely important and its separate drain instructions work for your home. The similar product names do not make these units interchangeable.
This assessment uses the exact Frigidaire U.S. product page, the model-named specification sheet and EnergyGuide, and the Complete Owner's Guide linked from that product page. The guide cover names the portable-air-conditioner family rather than this exact SKU; I use it only for instructions compatible with the exact cooling-only specification. Its hose minimum conflicts with the specification, so the lower hose endpoint remains unknown for matching. No independent cooling, sound, energy, reliability or air-cleaning measurement, hands-on ownership claim, retailer price, stock guarantee or room-area guarantee is offered.
Manufacturer sources and limits
Read Frigidaire's FHPW122AC1 product page, the specification sheet naming FHPW122AC1, its model-specific EnergyGuide and the Complete Owner's Guide linked from the exact product page. Compare its capacity and setup tradeoffs with the FHPC102AC1, FHPC142AA1 and FHPH142AA1.
Key details at a glance
| DOE seasonal-adjusted cooling capacity | 8000 BTU/h |
|---|---|
| Manufacturer's stated room area | 350 sq ft (stated, not a guarantee) |
| Documented modes | cool / dry / fan / auto |
| Dual-hose exhaust arrangement | No |
| App or connected control | Yes |
| Manufacturer's lowest sound claim | 49 dBA (claim, not our measurement) |
| Combined energy efficiency ratio on EnergyGuide | 7.2 CEER |
| Cabinet width | 16.5 in |
| Cabinet height | 28 in |
| Cabinet depth | 14 in |
| Listed product weight | 69 lb |
| Listed limited warranty | 1 years |
| Window-kit minimum width (where exact manual confirms) | 26.6 in |
| Window-kit maximum width (where exact manual confirms) | 52.5 in |
| ASHRAE cooling rating (separate test method) | 12000 BTU/h |
| Supplemental heat documented | No |
Use the exact model’s instructions for operating limits, supplied equipment and version differences.
Sources for this assessment
- Exact Frigidaire U.S. product page for FHPW122AC1
- Frigidaire specification sheet naming FHPW122AC1
- Model-specific Frigidaire EnergyGuide for FHPW122AC1
- Frigidaire Complete Owner's Guide linked from the exact FHPW122AC1 page; generic family cover
- Exact-page-linked manufacturer gallery image for FHPW122AC1
Keep the model number in the decision.
Check the listed suffix, included vent kit, room conditions and service instructions before ordering.
